Ricoh AP4510 - Manual (Page 413)

3
K
Lock the printer board with the
two screws you removed in step
D .
Note
❒ Be sure to return the screwdriv-
er to the paper tray after using
it.
❒ Print a configuration page to
confirm that the unit is properly
installed. See "Printing a Config-
uration Page" in the Printer Ref-
erence, on the CD-ROM labeled
"Operating Instructions".
Connecting the 1394 interface
cable to the printer
A
Attach the 1394 interface cable to
the jack on the board.
Both jacks are available.
B
Connect the other end of the 1394
interface cable to the computer or
the other IEEE 1394 node.
Note
❒ The 1394 Interface Unit could not
receive data from more than one
PC at the same time. In this case, an
error message appears. The printer
can accept data sent from other
computers, after the first print job
has finished.
❒ The bidirectional transmissions
are not supported by the 1394 In-
terface Unit.
❒ When the 1394 Interface Unit is in-
stalled successfully, the printer
icon automatically changes from
"Use Printer Offline" to "Ready",
according to the 1394 interface ca-
ble plug.
❒ To use the 1394 Interface Unit, con-
figure the unit from the control
panel of the printer.