Ricoh AP4510 - Manual (Page 250)

Windows 95/98/Me Configuration
10
1
Setting Up a Client Computer
This section describes the procedures for setting up a client on a network that
uses Windows 2000, Windows NT Server or Windows NT Workstation as a
print server.
When using a Windows 2000 or Windows NT print server, select a shared print-
er on Windows 2000 or Windows NT.
Limitation
❒ When using a print server connected to the printer with Ridoc IO Navi, you
cannot use Recovery Printing.
Note
❒ This section assumes that the client has already been configured to communi-
cate with a Windows 2000 or Windows NT print server. Do not begin the fol-
lowing procedure until the client has been set up and configured correctly.
AAAA
Install the printer driver as a local printer.
Reference
For more information about installing the printer driver, see the Setup
Guide.
Note
❒ Any port can be selected during the installation, however, LPT1 is recom-
mended.
BBBB
Click [Start], point to [Settings], and then click [Printers].
CCCC
Click the icon of the printer you want to use. On the [File] menu, click [Prop-
erties]
.
Windows 2000 or
Windows NT Print Server
Windows 95/98/Me