Ricoh AP4510 User Manual

Page 150

Advertising
background image

Troubleshooting

76

5

Possible Cause

Solutions

Is the Data In indicator
blinking or lit after starting
the print job?

If not blinking or lit, the data is not being sent to the printer.

❖

❖

❖

❖ If the printer is connected to the computer using the in-

terface cable

Make sure the printer port settings are correct. For a parallel
port connection, port LPT1 or LPT2 should be set.

• Windows 95/98/Me

A

Click [Start], point to [Settings], and then click [Printers].

B

Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].

C

Click the [Details] tab.

D

Check the [Print to the following port] box to confirm that
the correct port is selected.

• Windows 2000

A

Click [Start], point to [Settings], and then click [Printers].

B

Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].

C

Click the [Port] tab.

D

Check the [Print to the following port] box to confirm that
the correct port is selected.

• Windows NT 4.0

A

Click [Start], point to [Settings], and then click [Printers].

B

Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].

C

Click the [Port] tab.

D

Check the [Print to the following port] box to confirm that
the correct port is selected.

❖

❖

❖

❖ Network Connection

Contact your network administrator.

Do you print via a net-
work?

Confirm that the "Ethernet" setting is correct from the control pan-
el. See p.122 “Host Interface Menu”.
The setting governs the data transfer speed used by the Network
Interface Board. Three options are available:

• Auto (default)

• 100 Mbps

• 10 Mbps

Note

❒ For details about the appropriate setting to use on your net-

work, contact your network administrator.

Advertising