Ricoh Priport JP5000 - Manual (Page 292)

Operation
40
1
Erasing Center and Edge Margins
When printing from thick books, or
similar originals, the binding margin
at the center and the edges might ap-
pear on prints. To prevent this, per-
form the following steps.
Important
❒ Be sure to keep the platen cover at
an angle of at least 25 degrees with
the exposure glass.
❒ If you do not press hard on the
book while it is scanned, the mar-
gin at the center might no be
erased completely.
Note
❒ If your originals have solid images
at the edges, the machine might
recognize the solid images as shad-
ows and not copy them. In this
case, use Edge Erase mode so that
only the shadows are not copied.
See p.41 “Edge Erase”.
AAAA
Set the book on the exposure
glass.
BBBB
Keep the exposure glass cover at
an angle of at least 25 degrees
with the exposure glass.
CCCC
Press the
{{{{Start}}}} key.
Note
❒ Press hard on the book with
your hand while it is scanned.
DDDD
Check the image position on the
trial or proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the [Image
= = = =]
key. See p.24 “Adjusting the Po-
sition of Printed Images”.
EEEE
Make your prints.