Ricoh Priport JP5000 - Manual (Page 44)

OPERATION
22
1
Loading Paper On The Paper Feed Tray
The Load Paper indicator (
B) lights
when the paper feed tray runs out of
paper.
Replenishing Paper
A
Press the
{{{{
Clear/Stop
}}}} key.
Note
❒ This step is necessary only if
you want to pause a print run to
replenish paper.
B
Press the Paper Feed Tray Down
key.
Note
❒ The paper feed tray will lower
without the key being pressed
when printing paper runs out.
❒ The top sheet might remain be-
tween the feed rollers. In this
case, remove the top sheet.
C
Load paper on the paper feed tray.
Note
❒ If you wish to set a different
kind of paper, select the appro-
priate paper type with the
[Ppr.
Type] key. See
⇒
P.42 “Printing
On Various Kinds Of Paper”.
❒ Release the pads of the feed
side/end plates before loading
paper. Reset the pads after pa-
per is set.
❒ Correct paper curl before set-
ting the paper.
D
Press the
{{{{
Print
}}}} key to resume
printing.
Program Clear Modes
Auto Cycle
Proof
Print
Enter
Start
Clear/Stop
TPES080N
TPEH130E
TPEY040E
Program Clear Modes
Auto Cycle
Proof
Print
Enter
Start
Clear/Stop
TPES070N