Ricoh Priport JP5000 - Manual (Page 322)

Operation
70
1
Skip Feed Printing
You can increase the time between
prints using the
{{{{Skip Feed}}}} key. By de-
fault, when one sheet of paper is fed,
the drum rotates twice. However, you
can select the number of drum rota-
tions. This gives you a chance to re-
move prints one by one from the
paper delivery tray or insert one sheet
of paper between two prints. If you
use this function, you can also use pa-
per longer than the length limitation
of 432mm, 17.0".
Note
❒ For every sheet of paper fed, the
drum rotates twice by default. You
can change this default setting
with the user tools. See “No. of
Skip Feed” on p.144 “4. Mode Set-
ting”.
❒ The maximum length of paper in
Skip Feed mode is 460mm, 18.1".
❒ When you use paper longer than
432mm, 17.0", prints will not be de-
livered to the paper delivery tray
properly, so lower the paper deliv-
ery end plate and take out the
prints by hand.
AAAA
Place your original on the expo-
sure glass or in the optional docu-
ment feeder.
BBBB
Press the
{{{{Skip Feed}}}} key.
CCCC
If necessary select the number of
drum rotations per sheet of paper
fed with the [
← ← ← ←] [→ → → →] or {{{{~ ~ ~ ~}}}} {{{{} } } }}}}}
keys.
Note
❒ You can also select the number
of rotations with the number
keys.
❒ You can select from 2 to 9 rota-
tions.
❒ By default, the machine asks
you to confirm the number of
rotations. You can have this step
omitted by adjusting the user
tool settings. See “No. of Skip
Feed” on p.144 “4. Mode Set-
ting”.
DDDD
Press the [OK] key.
EEEE
Press the
{{{{Start}}}} key.
Skip Feed Edge Erase
Over lay
Make-Up
Stamp
Image Density
Lighter
Darker 2
Darker 1
Normal
Economy Mode
Original Storage Job Separator
Auto On Line
On Line
ZDZS030N