Placing originals, Placing originals on the exposure glass – Ricoh SP3510SF User Manual
Page 121
In copier mode
In scanner mode
In fax mode
Left
3 mm
0 mm
1 mm
Bottom
4 mm
0 mm
2 mm
Placing Originals
This section describes the procedure for placing originals on the exposure glass and in the ARDF or ADF.
• Do not place originals before any correction fluid and toner has completely dried. Doing so may
make marks on the exposure glass that will appear on copies.
• The original in the ARDF or ADF takes precedence over the original on the exposure glass if you
place originals both in the ARDF/ADF and on the exposure glass.
• Because colors made by marker or highlighter pen on originals are difficult to reproduce, they
might not appear on copies.
Placing originals on the exposure glass
The exposure glass enables you to scan and send documents that cannot be fed into the ARDF or ADF.
• Do not lift the ARDF or ADF forcefully. Otherwise, the cover of the ARDF or ADF might open or be
damaged.
1.
Lift the ARDF or ADF.
Be careful not to hold the input tray when lifting the ARDF or ADF, for the tray might be damaged.
2.
Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
CMF048
Placing Originals
119