Ricoh SP3510SF - Manual (Page 404)

Message Causes Solutions
Dial Failed The fax could not be sent.
• Confirm that the fax number you
dialed is correct.
• Confirm that the destination is a fax
machine.
• Confirm that the line is not busy.
• You may need to insert a pause
between dial digits. Press the [Pause/
Redial] key after, for example, the
area code.
Exceeded Max.E-
mail Size
The scan file exceeds the size
limit for files that can be sent
through e-mail.
• Configure [Resolution] under scanner
settings to reduce the scanning
resolution. See p.263 "Scanner
Settings".
• Configure [Max. E-mail Size] under
scanner settings to increase the
allowed size. See p.263 "Scanner
Settings".
Failed to Access File
Press Clear key
The Scan to USB function failed
because the machine could not
access the USB flash disk
properly.
Use a USB flash disk that is not password-
or write-protected.
Failed to Create File
Press Clear key
The Scan to USB function failed
because there was not enough
memory on the USB flash disk.
Use a USB flash disk with enough memory.
Fax Job Memory
Overflow
The number of fax jobs in
memory (unsent or unprinted
faxes) has reached maximum,
so new jobs cannot be stored.
Wait until pending jobs have been
transmitted or printed.
I-Fax POP3 fails
Connection to the POP3 server
failed.
• Confirm that the network cable is
properly connected to the machine.
• Confirm that the network settings such
as IP address, DNS, and POP3
settings have been configured
properly (make sure that no double-
byte character is used). See p.330
"Configuring the Network Settings".
9. Troubleshooting
402