Assigning the machine's ipv4 address manually – Ricoh SP3510SF User Manual

Page 73

Advertising
background image

• You can press the [Escape] key to exit to the previous level of the menu tree.
• A password for accessing the [Network Settings] menu can be specified in [Admin. Tools Lock].
• If your network environment requires a specific transmission speed that is not automatically

detected, set the transmission speed in [Set Ethernet Speed] under [Network Settings].

• When [DHCP] is activated, manually configured IPv4 address settings are not used.

For details about turning the machine on and off, see p.55 "Turning the Power on".
For details about printing the configuration page, see p.291 "Printing the Configuration Page".
For details about [Admin. Tools Lock], see p.298 "Administrator Settings".
For details about [Set Ethernet Speed], see p.75 "Configuring the Ethernet Speed".

Assigning the machine's IPv4 address manually

• The IPv4 address assigned to the machine must not be used by any other device on the same

network.

1.

Press the [User Tools] key.

CMF134

2.

Press the [ ] [ ] keys to select [Network Settings], and then press the [OK] key.

3.

If you are requested to enter a password, enter the password using the number keys,
and then press the [OK] key.

4.

Press the [ ] [ ] keys to select [IPv4 Configuration], and then press the [OK] key.

5.

Press the [ ] [ ] keys to select [DHCP], and then press the [OK] key.

6.

Press the [ ] [ ] keys to select [Inactive], and then press the [OK] key.

7.

Press the [ ] [ ] keys to select [IP Address], and then press the [OK] key.

The current IPv4 address is shown.

Configuring the Machine

71

Advertising
This manual is related to the following products: