Specifying the scan settings – Ricoh SP3510SF User Manual

Page 193

Advertising
background image

Specifying the Scan Settings

This section describes how to specify the scanning size, image density, and resolution for the current job.
When a scan destination is specified

When you specify a scan destination, the machine's scan settings change automatically according
to the information registered for that destination in the Address Book.
This allows you to send scanned files without having to reconfigure the scan settings according to
each destination. If necessary, you can change the scan settings using the control panel.

• The machine maintains the preset scan settings for the current destination until the machine returns

to standby mode.

• Changing the preset scan settings for the current destination does not change the information

registered in the Address Book.

• If you specify the last used destination, the preset scan settings become effective again, even if you

have changed the settings for the previous job.

Specifying the scanning size according to the size of the original

This section describes how to specify the scanning size according to the size of the current original.

1.

Press the [Reduce/Enlarge] key or [Scn Size].

CMF136

2.

Press the [ ][ ] keys to select the size of the original, and then press the [OK] key.

If you selected anything other than [Custom Size], you do not need to perform the remaining steps
of the procedure.

3.

Press the [ ][ ] keys to select [mm] or [inch], and then press the [OK] key.

4.

Enter the width using the number keys, and then press the [OK] key.

To enter a decimal point, press [ ].

Scanning Using the Control Panel

191

Advertising
This manual is related to the following products: