Default settings – VXI 3002 User Manual
Page 35
3-5
Default settings
The instrument is reset to the factory default settings in the following cases:
(1) At power-up.
(2) Following execution of the RCL 999 command.
(3) Following execution of the *RST command.
The default settings are shown in Table 3-1 .
Table 3-1 Instrument default settings
Carrier frequency
:
Step
:
2.4 GHz
1 kHz
RF level
Step
:
Status:
RF output :
−137 dBm
1 dB
ON
Enabled
Modulation mode
Internal FM, modulation disabled
Modulations
:
FM1
:
Deviation: 0 Hz, OFF
:
Internal source, frequency: 1 kHz, sine
FM2
:
Deviation: 0 Hz, OFF
:
Internal source, frequency: 400 Hz, sine
ΦM1
:
Deviation: 0 rad, OFF
:
Internal source, frequency: 1 kHz, sine
ΦM2
:
Deviation: 0 rad, OFF
:
Internal source, frequency: 400 Hz, sine
AM1
:
Deviation: 0%, OFF
:
Internal source, frequency: 1 kHz, sine
AM2
:
Deviation: 0%, OFF
:
Internal source, frequency: 400 Hz, sine
Pulse
:
OFF
Modulation steps :
∆FM 1 kHz, ∆ΦM 0.1 rad, ∆AM 1%
Mod frequency steps :
10 Hz
Carrier sweep
Freq
mode:
Mode
:
Type:
Ext trigger :
Start
:
Stop:
Step
size:
Time:
Fixed
Single sweep
Linear
OFF
9 kHz
2.4 GHz
1 kHz
50 ms