V-Tech CAT5 System Technical Guide - Manual (Page 107)

Page 107 K5 System Technical Guide
IP Seg: Select a IP Segment for the new project. Note that all the IP address must be in the same
segment.We will take 192.168.0.X as an example in this manual
System Type: IP-device can be used in DT or C5 system, here we choose C5.
Project Name: Name of the new project; we will name K5 System as an example in this manual
Project Description: Can input some info about project
Project Mark: Can input some info about project
Insert time line: Insert the created time in K5 System frame.
When finish the basic setting, click on Save to save the project information.
5.3.4§IP§Node§Config
Now when the project property is finished, we can begin to add all the devices to the project.
Right click on K5 System, and then select IP Node Config. Select IP nodes which will be adopted in
this project and then select its model and name of the device.
IP Nodes Description
IP Nodes Description
192.168.0.(2 to 240) Door Station/ Common Door Station/ Camera
192.168.0.(241 to 246) Switchboard ( IP-Agent )
192.168.0.(247 to 254) Switchboard (IP-G21)