V-Tech CAT5 System Technical Guide - Manual (Page 22)

Page 22 K5 System Technical Guide
2.3.2.4§§Indoor§Monitor§Functions
Receiving calls
Call from door station: When the monitor rings, it means a call is coming. The display will show the
video from the door station camera, press the answer button to accept the call and press the an-
swer button again to end the call after finish the conversation Call from Switchboard: When hand-
set rings, the display can show the video from the Switchboard camera(if the Switchboard is fitted
with one camera). Press the answer button to accept the call and press the answer button again to
end the call after finish the conversation call from other monitor: The monitor will ring and show
the interface of intercom call. Two icon buttons will be shown on the screen for different opera-
tion: pick up or refuse.
Call other devices
Call Switchboard: While in standby, press the directly call Switchboard to call the Switchboard and
wait for it to answer the call. Press end button to end the conversation. The device will go back to
standby status. Call other monitor: Press intercom call to enter the intercom call interface, then in-
put the room number to call other monitor.
Monitoring
While in standby, press the monitor button, the display will show the picture video of the door sta-
tion. If there are several door stations, two ways of monitoring can be run: automatic and manual.
In automatic monitoring, the display will show all door stations’ pictures one by one; in manual
way, the display just show the picture which is selected. During monitoring, talk and unlock func-
tions are available.
2.3.2.5§Specification
Power supply: DC 24V (supplied by system)
Power consumption: Standby 1W; Working status 5W
Monitor screen: 7 Inch color LCD
Display Resolutions: 800 x 480 pixels
Video signal: 1Vp-p, 75Ω, CCIR standard
Wiring : CAT5 cable, polarity
Dimension: 125(H) ×225(W) ×23(D) mm
Chapter 2 K5 System Parts