V-Tech CAT5 System Technical Guide - Manual (Page 41)

Page 41 K5 System Technical Guide
§ § 4.1§Door§station§Setting
4.1.1§Door§station§working§mode
Door station is to be installed in the entrance, to communicate with monitors or with Switchboard.
Door station can be set to work under two modes:
1. Unit door station
To be installed on the entrance of each separate building, being able to call all the monitors inside
the building
2. Common door station
To be installed on the common entrance, being able to call all the monitors inside the LAN net-
work
4.1.2§§IP-MR9L§Configuration
Door stations can work in Normal mode and Debug mode. Normal mode is for daily function for
tenants; Debug mode is used for the installer, and debug tool can be activated under this mode.
4.1.2.1§§How§to§enter§debug§mode
Door station is to be installed in the entrance, to communicate with monitors or with Switchboard.
Door station can be set to work under two modes:
When Door Station is
standby, press “#” key Input “9008”, then input Admin
Code (“66666666” by default) Debug Mode menu is
launched
Working Mode Function
Normal mode Daily use for tenants: calling, talking, unlocking
Debug mode Special mode for installer: quick access to all settings and debug tools
V i d e o E n t r y S y s t e m
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> > D E B U G S T A T E < <
- - - - - - - - - - - - - - - - - - - - - - - - - - -
3 - # M o n i t o r P r o g r a m
2 - # S e t u p
1 - # I n s t a l l e r S e t u p
6 - # O n l i n e D e v i c e s . . .
E X I T: # - 9 0 0 9
5 - # O n l i n e M o n i t o r. . .
- - - - - - - - - - - -To o l s - - - - - - - - - -
4 - # C a r d M a n a g e
V i d e o E n t r y S y s t e m
[ **** ]
1 2 3
4 5 6 7 8 # 0 * 9
S y s t e m R e a d y
V i d e o E n t r y S y s t e m
S y s t e m R e a d y