V-Tech CAT5 System Technical Guide - Manual (Page 43)

Page 43 K5 System Technical Guide
4.1.2.3§Basic§program§settings
• Installer Setup (Debug State->1.Installer Setup)
Item Descriptions Factory Set
1. DS Serial NO.
0 ---- Set as Unit door station. No C5-IPC connected. Set to 0,
then input 1/2/3 to select the related distributor type.
1. F411 ------> C5-F4
2. F414 ------> C5-F414
3. F422 -------> C5-F422
1~8 --- Set as Unit door station. C5-IPC connected. Only one
door station connected: set to 1.When C5-MDS connected,
1st C5-MDS related to 1 -- 4
2nd C5-MDS related to 5 -- 8
9 ----- Set as Common door station
[0-11]
Standalone
Used with
F411
2. Unlock Timing
To set the time that how long the door keeps open when
door is released. Ranging from 1 to 99 seconds.
[01]
3. Unlock Output
To set the relay state for unlock, can be set to be normally
open or normally closed
[0]
Normally
open
4. Card Memory
To choose to use the memory of door station or that of C5-
IPC when access cards are in use
0- Store and read cards from the memory of Door station
1- Store and read cards from C5-IPC
[0]
Use memory
of DS for ac-
cess
5. Doorplate Mode
To choose the input mode when you call monitor. It can
be set to from 1 to 8 digits. totally 8 numbers or 8 letters or
mixed are available
4 digits of
number
6. Audio Options…
To set the audio match between door station and monitor
and that between door station and Switchboard, it can be
used when there is audio match problem such as noisy or
discontinuous voice.
[0]
7. Parameters The parameters will take effect only when there is no C5-IPC
See
Parameters
8. Installer Code To change the Installer Code of door station [66666666]
9. Default
To retrieve the original configuration of Door Station. Note
this operation is an irreversible operation. Once restore is
done, the parameters including Installer Code and Setup
Code will return to Factory default setting