V-Tech CAT5 System Technical Guide - Manual (Page 51)

Page 51 K5 System Technical Guide
• Installer Setup (Debug State->1#->1. Installer Setup->7. Parameters)
Three pages are available inside the parameters, press # to switch between different pages
Table 1
Table 2
Item Descriptions Factory Set
1. Monitor Numbs
To set number of monitors that can monitor the door station
at the same time
[2]
2. Monitor Timing The maximum monitoring time [30]
3. Monitor & Talk Enable/Disable talk function when monitoring
[1]:
Enable
4. Monitor & unlock Enable/Disable unlock function when monitoring
[1]:
Enable
5.Wait Timing Maximum wait time when making a call [30]
6. Talk Timing Maximum talk time available in a call [90]
Item Descriptions Factory Set
1. Ring Numbers
To set the monitor coded 0099 as local Switchboard, so when
the user does ”Call Switchboard ” on the monitor, the call will be
transferred to the 0099 monitor
[0]
Not
activated
2. Name List Mode Reserved
3. Local IM as GU
To set the monitor coded 0099 as local Switchboard, so when
the user does ”Call Switchboard ” on the monitor, the call will be
transferred to the 0099 monitor
[0]
Not
activated
4. Multi IM Mode
To set the code rule when there are extended monitors in the
one apartment
[0]
Default
rule
5. Room Table Valid
To use the room table to call the monitor when room table is
downloaded to the door station through ST-Config
[0]
Not
activated
6. Room Table Only Reserved