V-Tech CAT5 System Technical Guide - Manual (Page 50)

Page 50 K5 System Technical Guide
4.1.3.3§Basic§program§settings
• Installer Setup (Debug State->1#->1.Installer Setup)
Item Descriptions Factory Set
1. ID Code.
1.When there is only one door station and no C5-IPC, set to 0.
And set the type of distributor used with it. When C5-IPC is
connected, must not be set to 0.
2. When C5-MDS is connected, be set to from 1~8 according
to which port it is connected on the C5-MDS
3. When used as common door station, set to 9
[0-11]
Standalone
Used with
F411
2. Unlock Timing
To set the time that how long the door keeps open when
door is released. Ranging from 1 to 99 seconds.
[01]
3. Unlock Output
To set the relay state for unlock, can be set to be normally
open or normally closed
[0]
Normally
open
4. Card Memory
To choose to use the memory of door station or that of C5-
IPC when access cards are in use
0-Use memory of DS for access
1-Use C5-IPC for access
[0]
Use memory
of DS for ac-
cess
5. Doorplate Mode
1. To choose the input mode when you call monitor. It can
be set to from 1 to 8 digits. totally 8 numbers or 8 letters or
mixed are available
2. Set to 0 to activate call directly after entering the number;
Set to 1 to activate the call by # following the number
[0]
4 digits of
number
6. Audio Options…
To set the audio match between door station and monitor
and that between door station and Switchboard, it can be
used when there is audio match problem such as feedback
or discontinuous voice
[0]
7. Parameters The preset parameters when ID Code is set to 0.
See
Parameters
8. Installer Code To change the Installer Code of door station [66666666]
9. Default
To retrieve the original configuration of Door Station. Note
this operation is an irreversible operation. Once restore is
done, the parameters including Installer Code and Setup
Code will return to Factory default
Chapter 4 K5 System Settings