V-Tech CAT5 System Technical Guide - Manual (Page 30)

Page 30 K5 System Technical Guide
• JWP: Power input. P+, positive 24V; P-,
negative.
• JWB (IN1, IN2, IN3, IN4): Connected to
door stations (Max.4).
• PA: Test button. Press PA, the IN-USE
indicator will light, and then start to
monitor door station connected circu-
lar with click of relay.
• S1: DIP Switch function setting, refer to
DIP switch setting.
• SW1: Always set to the 2V, 2A position.
• JTAG: update port. Connected to PC to
update the firmware of C5-MDS
• RS-485: PC port. Used to update the firmware of C5-MDS.
Specification
• Power input: DC 24V
• Standby Current: 50mA
• Working Current: 80mA
• Connection Port: RJ45
• Working temperature: -10 0 C ~ +40 0 C
• Dimension: 140*150*60 mm
2.3.4.6§Picture§Memory§Controller:§C5-IMC
C5-ICM is independent picture memory controller for K5 system. When visitor call the monitor, the
C5-IMC will start to capture picture and save it, the resident can view the picture on the indoor
monitor.
• Picture playing is continuous and the switch time can be set by DIP switch
• Up to 800 pictures can be saved
Parts and functions
• S201: DIP switch
• PA201: Capture picture in normal status, for DIP test in test status
• PA202: Play picture in normal status, for EEPROM test in test status
• PA203: Exit in normal status, for monitor communication in test status
C5-MDS
JWB(IN4)
P- P+ P- P+ PA S1
1
ON DIP
2 3 4 5 6
JWB(IN3) JWB(IN2) JWB(IN1) JWB(OUT)
JWB(OUT)
T/R- ERROR INUSE LINK POWER T/R+
JWP PA S1 ERROR
IN-USE
LINK
POWER
RS-485
JWB(IN4) JWB(IN3) JWB(IN2) JWB(IN1)
Chapter 2 K5 System Parts