V-Tech CAT5 System Technical Guide - Manual (Page 122)

Page 122 K5 System Technical Guide
5) Monitor
Monitor Switch Timer:
Set the time duration
of each port when do
monitoring on the
monitor
Monitor 1~8: Set the
channels available
when do automatic
monitoring on the
monitor, it switches
from one to another
by turn
6) Advanced
• IP8210 control
This item is reserved,
don’t change the set-
ting easily.
• Special function
IMC: Set Enable/Dis-
able for IMC
F4XX driver: Set the
Distributor type
G Call Type: When
the switchboard calls
monitor, to set it as a
network call or a DS
call
IMC Monitor Timer: To the time duration of each photo, when monitor is browsing the photos re-
corded in IMC
• Call Table Quan
Rows of Common Call Table: To set the limitation of rows when making the Common call table
Rows of IP Table: To set the limitation of rows when making the IP call table
Rows of Room Call Table: To set the limitation of rows when making the Local call table
does the monitoring. It always surveys camera port , skips the door station port when off line and
skips None port always.
Chapter 5 K5 System Softwares