V-Tech CAT5 System Technical Guide - Manual (Page 28)

Page 28 K5 System Technical Guide
Specifications
Power supply: DC24V
Standby current: 60mA
Working current: 120mA
Working temperature: -10 0 C~40 0 C
Connection port: RJ45
Dimensions: 140*150*60mm
2.3.4.4§IP§Converter:§C5-IPC
C5-IPC is a network controller. It serves as system controller, manages all the data in the system
communication. To severs as a IP converter to effect the network connection.
• Built-in watchdog circuit in case of crash
• LED Indicators to show system status
• RJ45 Standard connection port
• Talking volume adjustable
• Support TCP/IP network and fiber transmission or broadband network access
• Adopt MPEG4 video protocol and G.729 audio protocol
• Include 100Mbit Ethernet LAN and RS485 connection port
Parts and Functions
• PA: Reset. Press and hold PA for 3 seconds
to initialize C5-IPC; If initialization com-
plete successfully, power off, and re-power
C5-IPC, LINK&IN-USE indicators will flicker
once simultaneously, then INK indicator
will flicker till IN-USE indicator is always
ON
• S1: DIP Switch. Refer to DIP Switch Setting
• JTAG: PC Port. Update C5-IPC program by
PC that is connected by RS232 convertor
• RS485: PC Port. Set parameters update
the firmware of C5-IPC by PC RS485-USB
convertor
• JWP: Power Input P+: Positive,24V; P-: Negative
• JWB (IN): Bus Signal Input. RJ45 port includes audio, data & video. It can be connected to door
1 2 3
P+ P- P+ P- RS485
SW1
JWB(IN) JWB(OUT) CN(MDS) ETHERNET
PA VR600
+
S1 POWER
LINK
IN-USE
AG
1
ON DIP
2 3 4 5 6
C5-IPC
JTAG S1 POWER PA VR600
IN-USE LINK
JWP RS-485 JWB(IN) CN-MDS
CN-NET JWB(OUT) SW1 JP1/2/3
Chapter 2 K5 System Parts