Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 23)

PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter 23
5. Assembly
Back Shield Assembly
A. The sweep has been broken down into four (4) different section types: the head, intermediate, tail
and extension sections.
NOTE: Use the Chart below to determine the identification and the order of assembly of the individual
sweep sections.
B. Use eight (8) 5/8"-11 x 1-3/4" grade 8 hex bolts, lock washers and hex nuts at each
section connection.
Figure 5A
12" Series II Sweep Sections
Bin Diameter
# of
Sections
Head Intermediate Intermediate Intermediate Tail Extension Pivot to End
131' 6 136" 144" 144" 60" 144" 137-1/2" 63.84'
135' 6 136" 144" 144" 84" 144" 137-1/2" 65.84'
CAUTION
The section sizes are total length given in inches. The head section has 8"
subtracted from the shield length due to the pivot pipe location.
The 12" tail section has 5-1/2" added to the shield length due to the end shaft length.
The bolts MUST be installed as shown in Figure 5A .
CAUTION