Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 59)

6. Start-Up
PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter 59
Start the Auger
A. Step on the foot switch and press the “Start” button.
B. Run the auger through a “break-in” period if it is being used for the first time or for the first time of
the season.
C. “Polish” the flighting by running the auger at partial capacity until it is smooth, before attempting
full capacity.
CAUTION
DO NOT start or stop the auger while it is under load.
CAUTION
Failures may occur if the auger is run full before it has been “polished” during
the “break-in” period.
CAUTION
NEVER operate the auger empty. Operating augers empty for any length of
time will cause excessive wear. NEVER operate the auger at speeds higher
than recommended.
CAUTION
Be aware of any unusual vibration or noises during the initial start-up and
“break-in” period. If anything unusual is detected, immediately shut down the
auger and disconnect and lock out the power supply before servicing.