Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 26)

5. Assembly
26 PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
Flange Bearing Assembly
A. Slide the flange bearing onto the end stub and bolt it to the end plate using hex bolts, lock washers
and hex nuts as shown in Figure 5F .
NOTE: Do not tighten the set screws on the bearing at this time. This can be done after the gear reducer
is installed.
Figure 5F
Gear Reducer Assembly
A. Slide the output shaft of the reducer through the end plate of the head section and into the end of the
head flight. Secure the reducer output shaft to the head flight with hex bolts and lock nuts.
(See Figure 5G on Page 27.)
B. Bolt the reducer to the end plate of the head section using hex bolts, flat washers and lock washers,
supplied with the reducer. (See Figure 5G on Page 27.)
NOTE: The input shaft of the reducer MUST be to the top of the reducer. Refer to Owner’s manual
supplied with the reducer for proper vent plug, fill plug and drain plug locations.