Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 49)

5. Assembly
PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter 49
3. Feed the power cord through the pivot tube. (See Figure 5AI.)
4. Align the hole in the back shield with the pivot tube and push the sweep onto the pivot tube.
(See Figure 5AI.)
5. Connect the pivot plate to the back shield using two (2) 1/2"-13 x 1-3/4" hex bolts, flat washers,
lock washers and hex nuts. (See Figure 5AI.)
6. Fasten the pivot rod to the back shield and pivot plate using two (2) 1/2"-13 x 2" hex bolts, lock
washers and hex nuts. (See Figure 5AI.)
7. Screw the 45° grease fitting into the pivot assembly pipe. (See Figure 5AI.)
Figure 5AI