Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 50)

5. Assembly
50 PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
8. Connect the 1" x 48" liquid-tight flex conduit to the pivot tube using one 1" conduit coupling and
one 1" liquid-tight flex conduit coupling. (See Figure 5AJ.)
9. Connect the 1" x 48" liquid-tight flex conduit to one of the junction boxes using one 1" liquid-tight
flex conduit coupling. Connect the leads as required. (See Figure 5AJ.)
10. The customer is to provide proper power cord protection between the pivot assembly and the
sump transition. (See Figure 5AJ.)
Figure 5AJ
11. The multi-conductor power cord can be connected with the 14 AWG/3 wire, 14 AWG/4 wire and
10 AWG/4 wire cords in an explosion proof junction box.
12. Hardwire foot switch to terminal 3 and terminal 4 in control panel. (See Schematic on Pages 69-72.)
13. Hardwire motor thermostat J-wires to terminal 1 and terminal 2 in control panel. (See Schematic
on Pages 69-72.)
14. Hardwire motors to starters in control panel. (See Schematic on Pages 69-72.)