Jack support assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 User Manual
Page 46
5. Assembly
46
PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
Jack Support Assembly
NOTE: Be sure to use the spanner bushings, supplied with the caster wheels, between the caster and the
caster plate on each side.
A. Attach one caster wheel to the jack caster assembly using one 3/4" x 5-1/2" hex bolt, lock washer
and hex nut.
B. Locate the 2" x 2" x 12" tube to the right of each connecting angle and fasten the jack mount
assembly to the sweep frame using one jack mount plate, four (4) 1/2"-13 x 3-3/4" hex bolts, lock
washers and hex nuts.
C. Attach the jack caster assembly to the jack assembly using one pin.
D. Bolt the jack assembly to the jack mount assembly using four (4) 1/2"-13 x 2" hex bolts, lock washers
and hex nuts.
Figure 5AF Current Production Sweep Shown