Sheave installation – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 User Manual
Page 39
5. Assembly
PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
39
Sheave Installation
Figure 5W
A. Loosely bolt the bushing and large sheave together with the screws provided with the bushing.
B. Slide the bushing and large sheave onto the auger gear reducer input shaft with a key.
C. Loosely bolt the bushing and small sheave together with the screws provided with the bushing.
WARNING
To ensure that the drive is not unexpectedly started, turn OFF and lock out the
power source before proceeding. Failure to observe these precautions could
result in bodily injury.
CAUTION
Wedging forces in the bushing saw slot, such as that exerted by a narrow edged
regular screw driver, may damage or break the bushing. This damage would not
be covered under the GSI warranty.