Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 27)

5. Assembly
PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter 27
Figure 5G
Drive Axle Assembly and Bearing Support
A. Loosen set screws on bearings.
B. Replace standard grease zerks with 90° grease zerks on both bearings. Make sure the 90° grease
zerk is turned as shown in Figure 5H , so the zerks are accessible from the center of the tractor
drive stand.
Figure 5H Figure 5I
C. Slide the axle assembly between the legs of the tractor drive stand as shown in Figure 5I .
D. Rotate the pillow block bearings until the bases are facing up. (See Figure 5I.)
NOTICE
The gear reducer is NOT filled with oil from the factory. For gear reducer
specifications and oil fill recommendations, refer to lubrication section on
Page 64
of this manual.