Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 40)

5. Assembly
40 PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
D. Slide the bushing and small sheave onto the motor shaft with a key. (See Figure 5X.)
Figure 5X
E. Align the sheaves with a straight edge to assure proper alignment and tighten the screws on the
bushings. (See Figure 5X.)
F. Carefully install the belts onto the large and small sheaves. (See Figure 5Y on Page 41.)
NOTE: Adjust the hex nuts on the motor mount adjustment rod to attain correct belt tension while
making sure the motor mount is level on both rods. The motor mount must be parallel to the
auger screw to allow for proper sheave alignment.