Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-751-G2 - Manual (Page 30)

5. Assembly
30 PNEG-751-G2 12" Series II Sweep 131' and 135' Diameter
Key Alignment
A. Place key in keyway on drive shaft.
B. Make sure key is flat (parallel to drive shaft) in keyway as in Figure 5M_1 and Figure 5M_2 . NOT
like Figure 5M_3 .
Figure 5M
CAUTION
All keys should be parallel to the drive shaft. If the key is not straight (parallel) the
gearbox quill sleeve will crack.
THIS TYPE OF DAMAGE IS NOT COVERED BY WARRANTY.