Asus GigaX2024B - Manual (Page 219)

GigaX2024B/M L2 Managed Switch CLI Manual
199
tx -> sets whether the interface can send flow-
control packets to a remote device
both -> sets whether the interface can receive and
send flow-control packets from a remote device
off -> disable an interface to operate with an
attached device that is required to send or receive flow-control
packets
on -> allows an interface to operate with an
attached device that is required to send or receive flow-control
packets
Command Mode Interface mode
No/clear
No flowcontrol
Show show interface IFNAME
Default receive on, send on
Description This command sets the interface flowcontrol method.
Examples ASUS(config-if)# flowcontrol both on
15.13 auto-negotiation
Syntax auto-negotiation
Parameters
Command Mode Interface mode
No/clear
no auto-negotiation
Show show l2_interface IFNAME
Default None or depends on ODM customer
Description Use the auto-negotiation configuration command on the switch
stack or standalone switch to set auto-negotiation status of the
port.
Examples ASUS(config-if)# auto-negotiation
15.14 speed (10|100|1000)
Syntax speed (10|100|1000)
Parameters