Asus GigaX2024B - Manual (Page 64)

GigaX2024B/M L2 Managed Switch CLI Manual
44
Default
Description
To show spanning-tree summary.
Example ASUS# show spanning-tree interface fa1/0/1
10.28 spanning-tree (enable|disable)
Syntax spanning-tree (enable|disable)
Parameters disable -> disables the Spanning Tree algorithm
globally for the switch
enable -> enables the Spanning Tree algorithm
globally for the switch
Command Mode Configure terminal mode
No/clear
spanning-tree disable
Show show spanning-tree active
Default Enable
Description Enable/Disable the spanning tree
Example ASUS(config)# spanning-tree enable
10.29 spanning-tree cost <1-200000000>
Syntax spanning-tree cost <1-200000000>
Parameters cost the path cost
<1-200000000> Valid range is from 1 to 200,000,000
Command Mode Interface mode
No/clear
no spanning-tree cost
Show show spanning-tree port detail IFNAME
Default 19
Description Use the spanning-tree cost configuration command on the
switch stack or standalone switch to set the spanning-tree path
cost.
Example ASUS(config-if)#spanning-tree cost 128
10.30 spanning-tree edge-port