Asus GigaX2024B - Manual (Page 26)

GigaX2024B/M L2 Managed Switch CLI Manual
6
No/clear lacp aggregation-link group delete IFNAME
Show show aggregation-link group [GROUPID]
Default No default lacp aggregation-link trunk group enable
Description This command sets the Link Aggregation Control Protocol (LACP)
operation add/set or disable for the trunk group ports on the
switch stack or on a standalone switch.
Example ASUS(config)# lacp aggregation-link group delete fa1/0/1
2.3 lacp system-priority <1-65535>
Syntax lacp system-priority <1-65535>
Parameters system-priority Priority of the system
<1-65535> Valid values are from 1 to 65535
Command Mode Configure terminal mode
No/clear
no lacp system-priority
Show show lacp system-priority / show running-config
Default The default is 32768.
Description This command sets the system priority for the Link Aggregation
Control Protocol (LACP) on the switch stack or on a standalone
switch.
Example ASUS(config)# lacp system-priority 2000
2.4 show lacp [GROUPID]
GX2024B GROUPID range is 1-6
Syntax
show lacp [GROUPID]
Parameters [GROUPID] valid group-id range is 1 to 32
Command Mode Privileged EXEC mode
Default
None or depends on ODM customer
Description Use the show lacp user EXEC command to display Link
Aggregation Control Protocol (LACP) channel-group information.
Example ASUS#show lacp 1