Asus GigaX2024B - Manual (Page 220)

GigaX2024B/M L2 Managed Switch CLI Manual
200
Command Mode Interface mode
No/clear
no speed
Show show l2_interface IFNAME
Default None or depends on ODM customer
Description Use the speed configuration command on the switch stack or
standalone switch to set speed status of the port.
Examples ASUS(config-if)#speed 100
15.15 shutdown
Syntax shutdown
Parameters
Command Mode Interface configuration
No/clear
no shutdown
Show show running-config
Default
Description
The shutdown command for a port causes it to stop forwarding.
You can enable the port with the no shutdown command.
The no shutdown command has no effect if the port is a
static-access port assigned to a VLAN that has been deleted,
suspended, or shut down. The port must first be a member of an
active VLAN before it can be re-enabled.
Only one management VLAN interface can be active at a time.
The remaining VLANs are shut down.
In the show running-config command, the active management
VLAN interface is the one without the shutdown command
displayed.
Examples ASUS(config-if)# shutdown
15.16 default-priority <0-7>
Syntax default-priority <0-7>
Parameters <0-7> Cos priority
Command Mode Interface mode