YSI 9300 Photometer User Manual
Page 135
Test Procedure - Total Chromium
1
Fill the pretreatment tube with sample to the 20 ml mark.
2
Add one level spoonful of Chromicol CR powder. Replace screw cap and
shake tube well for two minutes.
3
Allow tube to stand for two minutes.
4
Filter a portion of the solution dropwise into a round glass test tube. Discard
the first few drops and then fill to the 10 ml mark.
5
Add one Chromicol No 1 tablet, crush and mix to dissolve.
6
Add one Chromicol No 2 tablet, crush and mix to dissolve.
7
Stand for 10 minutes without disturbing the solution to allow full color
development and to enable any undissolved particles to settle.
8
Select Phot 100 on photometer.
9
Take photometer reading in usual manner (see photometer instructions).
10
The result represents the total soluble chromium concentration (trivalent and
hexavalent) as mg/l Cr (Result B).
11
The trivalent Chromium (Cr
III
) concentration is obtained by subtracting Result
A from Result B :-
Trivalent Chromium = Result B - Result A
Interferences
Levels of dissolved iron above 1 mg/l cause low results for chromium. To increase
the tolerance, repeat the test using two Chromicol No 1 tablets and one
Chromicol No 2 tablet. Tannin causes complexation which prevents a response in
the test.
________________________