Alpha Technologies FXM350_Micro350 UPS - Manual (Page 26)

017-241-B0 Rev B 24
5. Installation
WARNING!
To avoid personal injury or damage to the equipment, always use at least two installa-
tion personnel to remove the unit from its container.
5.1 Installation of the Micro350
WARNING!
Batteries or other components (with the exception of factory-installed components)
must not be installed until the Micro350 cabinet has been securely set in place at its per-
manent location. Transporting the unit with batteries installed may cause a short circuit,
fire, explosion, and/or damage to the battery pack, enclosure and installed equipment.
Damage caused by improper shipping or transporting a unit with batteries installed is
not covered by the warranty.
5.1.1 Mounting the Micro350 Enclosure
5.1.1.1 Mounting to a wooden pole
Have the following tools and materials on hand:
• 13 mm nut driver for the bolts that attach the cabinet to the mounting bracket.
• Two 5/8 inch diameter machine bolts (UNC tread); SAE (Grade 5 or better), length to suit the pole (not
provided).
• Two 5/8 inch diameter zinc-plated flat washers.
• Two 5/8 inch diameter hex nuts (UNC thread).
• Auger or drill for boring 3/4 inch diameter holes in the wood pole.