Alpha Technologies FXM350_Micro350 UPS - Manual (Page 29)

27 017-241-B0 Rev B
5.1.1.4 Mounting to a Wall
Have the following tools and materials on hand:
• 13 mm nut driver for the bolts that attach the cabinet to the mounting bracket.
• Four 1/4" x 1-1/8" lag bolts.
• Four 1/4" diameter flat washers.
• Drill with 1/8" bit for drilling pilot holes.
• Assorted sockets and wrenches.
Procedure:
NOTE:
If the wall structure is not strong enough to support the weight of the Micro350 enclo-
sure and batteries, use a wooden backing plate that has a minimum thickness of 1-1/4"
and a maximum width of 4" that is securely mounted to a wall stud or studs.
1. Using the mounting bracket as a template, drill 4 pilot holes (indicated by the arrows in the following
diagram) into the wall to accept 1/4" bolts.
2. Secure the mounting bracket to the wall with the 4 bolts and washers.
3. Secure the Micro350 enclosure to the mounting bracket with the supplied bolts.
Front Side
Wall or
studs
Figure 15 — Attaching the mounting bracket to the wall studs
NOTE:
To install a Micro XL3 enclosure,
first attach the XL to an XL3 kit.