Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 114)

Chapter
4
Chapter 4 Command Set 4-11
ADAM-4015/ADAM-4015T Command Table
Command
Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, baud rate, data format,
checksum status, and/or integration time for a
specified analog input module 5-4
$AA2 Configuration Status Returns the configuration parameters for the
specified analog input module
5-10
$AAF Read Firmware
Version Return the firmware version code from the
specified analog input module 5-12
$AAM Read Module Name Return the module name from the specified
analog input module
5-13
#AA Analog Data In Returns the input value from a specified analog
input module in the currently configured data
format 5-14
#AAN Read Analog Input
from Channel N Returns the input value from a specified channel
of analog input module in the currently configured
data format 5-16
$AA5VV Enable/Disable
Channels for
Multiplexing Enable or disable the individual channels in an
analog module 5-17
$AA6 Read Channel
Status Get the enable/disable status of all channels in
an analog module 5-18
#** Synchronized
Sampling Orders all analog input modules to sample their
input values and store them in special registers 5-21
$AA4 Read Synchronized
Data Returns the value that was stored in the specified
module's register after the #** command 5-22
$AAB Channel Diagnose Diagnose channel status in over range, under
range, and wire opening 5-24
$AA0Ci Single Channel
Span Calibration Calibrates a specified channel to correct for gain
errors 5-27
$AA1Ci Single Channel
Offset Calibration Calibrates a specified channel to correct for offset
errors 5-28
$AA7CiRrr Single Channel
Range Configuration Configure the input type and range of the
specified channel in an analog input module 5-29
$AA8Ci Read Single
Channel Range
Configuration Get the input type and range of the specified
channel in an analog input module 5-30
$AAXnnnn Watchdog Timer
Setting Set communication WDT cycle time from 0000 ~
9999 (unit: 0.1 second. if value is 0000, the
communication WDT function will be disable) 5-31
$AAY Read Watchdog
Timer Setting Read the cycle time setting of communication
WDT 5-32
$AAS0 Internal Calibration Internal self-calibration for offset and gain errors 5-33
$AAS1 Reload default
calibrating
parameter Reload factory default calibrating parameter to
overwrite current calibrating parameter 5-34