Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 125)

Command Set
4-22 ADAM 4000 Series User’s Manual
ADAM-4019+ Command Table
Command Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, baud rate, data
format, checksum status, and/or
integration time for a specified
analog input module 5-4
$AA2 Configuration
Status
Returns the configuration
parameters for the specified
analog input module 5-10
$AAF Read Firmware
Version
Return the firmware version code
from the specified analog output
module 5-12
$AAM Read Module
Name
Return the module name from the
specified analog output module 5-13
#AA Analog Data In Returns the input value from a
specified analog input module in
the currently configured data
format 5-14
#AAN Read Analog Input
from Channel N
Returns the input value from a
specified channel of analog input
module in the currently configured
data format 5-16
$AA5VV Enable/Disable
Channels for
Multiplexing
Enable or disable the individual
channels in an analog module 5-17
$AA6 Read Channel
Status
Get the enable/disable status of all
channels in an analog module 5-18
$AAB Get Operating Status Get the channel operating status When
bit value is 0, it mean this channel is in
normal operating, when bit value is 1, it
mean this channel is opening wire 5-24
$AA3 CJC Status Returns the value of the CJC
sensor for a specified analog input
module 5-25
$AA9SNNNN CJC Offset
Calibration Calibrates an analog input module to
adjust for offset errors of its CJC
sensors 5-26
(Continued on following page)