KT&C KVR-1601S - Manual (Page 165)

165
 Then, a user should be able to operate the Speed Dome camera directly with CP1300.
NOTE
 Please check Protocol and Baud rate before operating the Speed Dome Camera using CP1300.
11.5.3.2 Buttons
 (PRESET): Press number Key and PRESET then the camera will move to designated point.
 (PATTERN): Press number Key and PATTERN then the designated Pattern will run
 (AUTO): Press number Key and AUTO then the designated Auto will run.
 (TOUR): Press number Key and TOUR then the designated Tour will run.
 (SCAN): Press number Key and SCAN then the designated Scan will run.
 (HOLD): Press HOLD to lock the Keyboard. To unlock a user has to input Password. (Default password is 0000)
 : Press NEAR/FAR to adjust the focus of Speed Dome camera.
 : Press TELE/WIDE to adjust the zoom of Speed Dome camera.
NOTE
 SPD Control Mode is only supported when Speed Dome Camera is directly connected to CP1300.
WARNING
 DEPENDING ON THE PROTOCOL BEING USED BY THE SPEED DOME CAMERA, CONTROLLING CAMERA MENU
COULD BE DIFFERENT. PLEASE CHECK SPEED DOME CAMERA MANUAL.
NOTE
 When a Key does not Work after Set up
- If the communication speed of DVR and CP are not co-related, it may not work. Please make sure the Baud rate of Keyboard sets on
9.6kbps.
-
Press the button to enter PTZ mode and switch to DVR mode again.
-
Please reboot the DVR.
 When Tx Blinks Continually on the LED Window
- If Tx blinks continually without any operation, it may be caused by improper set up of Joystick.
- OFFSET of the Joystick may not appropriately set up.
-
Please do Joystick calibration.