KT&C KVR-1601S - Manual (Page 178)

178
13.1.7 System Connection Diagram
13.1.7.1 HDMI In/Out and HD-SDI In/Out Connections
 Connect an ‘HDMI OUT’ from a device to ‘HDMI IN’ of HSC 1100 using by HDMI cable.
 Connect an ‘HD-SDI OUT’ from HSC 1100 to ‘HD-SDI IN’ of HD-SDI device using by 75 ohm coaxial cable.
13.1.7.2 Video Component Input
 If users wish to link video component input (e.g. Divx, etc), assure that video component input and “COMPONENT IN”
connections are connected properly with same colors.
13.1.7.3 Power Supply Connections
 Plug the power supply adapter (DC 12V, 3.33A) which is included in this product to ’DC12V’ connector and plug another
side to power source and Input voltage is a free volt (100 VAC ~ 240 VAC).
13.1.8 Cable
 75 ohm coaxial cable
 HDMI cable
 Component cable
NOTE
The cables above are not included in the package.
13.1.9 Display
13.1.9.1 LEDs
KEYS Operating mode
Power LED
(Red)
• Light off: Converter off
• Light on: Converter on
Connection LED
(Green)
• Light off: Not connected
• Light on: Connected
13.2 HSC1200
13.2.1 Introduction
 HSC 1200 is an HD signal converter which converts video signal from HD-SDI to HDMI.