KT&C KVR-1601S - Manual (Page 80)

80
6.4 Setup
6.4.1 Local Setup - Device
 Please make sure the network setting of DVR has been done properly prior to the remote connection setting.
6.4.1.1 Remote Site Connection Setup
 Click Setup – Local Setup – Device to enter the setup and a dialog will pop up as below picture.
6.4.1.2 New Device Register
 Select “Device Connection List” on left-hand side and click [New] to register new devices.
 Describe the connection information as below. A user must fill in where information requested in bold.
- Device Name: Type the DVR name to be displayed in the server list pane. Please note that this name has no relation to
the ID registered in DVR. Users may create a name to be easily distinguished.
- Description: Type brief description of the site
- IP Address: Input IP address or Domain Name of DVR (check from the SETUP>DEVICES>Network in DVR)
- Command Port: Input Administrator’s number among port numbers set in DVR (check from the
SETUP>DEVICES>Network in DVR). Default port number is 5920
- Stream Port: Input Video/Audio number among port numbers set in DVR (check from the SETUP>DEVICES>Network in
DVR). Default port number is 5921
- Web Port: Input Web number among port numbers set in DVR (check from the SETUP>DEVICES>Network in DVR).
Default port number is 80.
- Login ID: Type authorized ID of the DVR. Default ID is admin.
- Login Password: Type correspond password of the ID. Default Password is 1111
- Confirm Password: Retype the password to confirm
- Pop up Display: A user can set both video and text-in pop up or beep on corresponding channel when event occurs.
Device