KT&C KVR-1601S - Manual (Page 51)

51
 This page shows information of HDDs installed in the DVR.
 When users install full storage device and DVD-RW including one e-SATA storage(C, F, G H, I and J Type), then following
procedures will be listed as below:
- 1. Internal SATA 1~4 Ports
- 2. External SATA 1~4 Ports
- 3. DVD-RW
 Under “Information”, it is possible to find the port number where each HDD is connected.
- For Internal SATA, [P1], [P2], [P3] and [P4] each represents internal Port 1, Port 2, Port 3 and Port 4.
- For External SATA, [E1], [E2], [E3] and [E4] each represents external Port 1, Port 2, Port 3 and Port 4.
 Users must format when:
- install new HDD
- add another HDD
- replace HDD
- move HDD (change installation port)
- remove HDD
 Use to delete or purge all normal recorded data from database. Please follow the procedure below.
① Click (  ) Clear All Data box.
② When a Message box asking “All the data will be deleted and cannot be restored. Proceed?” shows, choose ‘OK’ to
confirm.
③ Then, Progress window will display and the process starts.
④ When all data are deleted, a message box “HDD format has been completed.” will pop up.
NOTE
When users add used HDDs from the same type of DVR, users can access data in DVRs as Read-Only or keep
CAUTION
DELETED DATA CANNOT BE RESTORED .
 Please Click ( ) S.M.A.R.T and the following screen will display.
S.M.A.R.T
 S.M.A.R.T shows the status of HDD connected to the DVR.
 Click ( ) Refresh box to refresh status of HDDs as the S.M.A.R.T setup.
Notification
 A user can set Notification when BAD are detected by S.M.A.R.T.
 Check  Alarm out: users can set the alarm out, when “Bad” detects from HDDs. If Click ( ) ‘All’, all items are check/uncheck
at once.
 Check  Email: users can receive the email notification to registered email address, when Bad detects from HDDs. If Click ( )
‘All’, all items are check/uncheck at once.
HDD Format
S.M.A.R.T