KT&C KVR-1601S - Manual (Page 184)

184
13.4.7 Connector Wiring
13.4.7.1 4 In / 1 Out Analog to HD-SDI Connection
 Connect 4 ‘VIDEO OUT’ of Analog device to each of 4 ‘VIDEO IN’ of HSC 2410 using 75ohm coaxial cables.
 Connect an ‘HD-SDI OUT’ of HSC 2410 to ‘HD-SDI IN’ of the HD-SDI DVR using 75ohm coaxial cable.
13.4.7.2 Power Supply Connection
 Plug the power supply adapter (DC 12V, 3.33A) which is included in this product to ’DC12V’ connector and plug another side
to power source and Input voltage is a free volt (100 VAC ~ 240 VAC).
13.4.8 Cable
 75 ohm coaxial cable
NOTE
The cable above is not included in the package.
13.4.9 Display
13.4.9.1 LEDs
KEYS Operating mode
Power LED
(Red)
• Light off: Converter off
• Light on: Converter on
Connection LED
(Green)
• Light off: Not connected
• Light on: Connected
13.5 HSR1110
13.5.1 Introduction
 HSR 1110 is an HD SDI repeater to extend the signal transmission distance between HD-SDI devices. The transmission
distance is easily extended up to 150m and if it requires extending longer than 150m, it may connect another repeater to
extend the signal transmission and it will be extended up to another 150m.
13.5.2 Features
 1 in / 1 Out HD-SDI Repeater
 HD-SDI SMPTE 292M support(1080p, 1080i,or 720p)
 150m Extension of transmission distance
 Vertical Frequency Auto-Track(60,60/1.001)