Batch options tab – Luminex xPONENT 4.0 SP1 User Manual
Page 103
91
Touring the Software
Batch Options Tab
Use this tab to set options for acquisition and batch analysis.
FIGURE 58.
Batch Options Tab
This tab contains the following:
Batch Options. This section displays the following options:
•
Allow running a batch if the instrument is not warmed up - Allows batches to run if
the instrument is not warmed up.
•
Allow running a calibration if the instrument is not warmed up - Allows calibration
to run if the instrument is not warmed up.
•
Allow running a batch with expired reagents - Allows batches to run with expired
reagents.
•
Allow running a batch if XY temperature is not in range - Allows batches to run if
the XY temperature is not in range.
•
Allow running a batch if the instrument is not calibrated or verified - Allows
batches to run if the instrument is not calibrated.
•
Use Weighting as default option for quantitative analysis - Sets the weighting for
quantitative analysis to default to ON for new protocols.
•
Warn when saving/running a New Batch with New Protocol without saving the
Protocol and/or Standard and Control information - Enables a dialog box warning
when saving or running a new batch with a new protocol when you haven’t saved the
protocol and/or standard and control information.
•
Prompt for reacquiring of the last errored wells for an aborted partial batch -
Allows users to choose to reacquire aborted wells when resuming a stopped/partial
batch or to start with the next unacquired well.
Batch Settings. This section displays the following options: