Luminex xPONENT 4.0 SP1 - Manual (Page 39)

27
Touring the Software
Analytes Tab
Use this tab to select or edit analytes used in the batch or protocol.
FIGURE 14. Analytes Tab
This tab contains the following:
Analyte grid. A grid representing each analyte from 1 to 500. Drag the slider box at the
far left up or down, or click the blue up and down arrows to display the full range of
analytes. Select All selects all analytes, and Deselect All deselects all analytes. Click a
numbered analyte to select it; click the analyte again to deselect it. You can also click and
drag to select groups of analytes. Selected analytes are red. Deselected analytes are
gray. An analyte marked as an intra-well normalization bead is blue.
Default Analysis. The default analysis changes based on the Analysis Type selected in
the Settings tab. You can change the analysis settings for all analytes by clicking Change
if the button is enabled in this tab. This displays the Analysis Settings dialog box.