Luminex xPONENT 4.0 SP1 User Manual
Page 41
29
Touring the Software
Total Count. Select Stop after bead count reaches: to stop acquisition when the bead
count reaches a certain number determined by the user. Type the desired value in the box.
The default value is 100.
You can also specify the minimum allowable bead count per well that the xPONENT
®
software analyzes. This excludes data from any beads carried over during acquisition. For
information about this feature, see “Batch Options Tab” on page 91.
Selected Analytes List. Selected analytes appear in a list on the right side of the analyte
grid. This list includes the following information:
•
Name - The name of the analyte. Click and type to rename the analyte.
•
Analysis - To change the type of analysis for an analyte, click this field to open the
Analysis Settings dialog box and select another analysis from the list.
FIGURE 16.
Analysis Settings Dialog Box
•
Select a method from the Method list.
•
If necessary, select a weight type from the Weight Type list.
•
Apply the analysis to all analytes in the list by clicking Apply to All Analytes.
•
Select Mark as Intra-Well Normalization Bead to make the analyte an intra-well
normalization bead.
•
Add a range to the analysis by clicking Add Range.
•
Select Use Threshold Ranges to enable ranges for the analysis.
•
Click Add Range to add a range.