Luminex xPONENT 4.0 SP1 - Manual (Page 105)

93
Touring the Software
Alert Options Tab
Use this tab to set options for alerts about various system events.
FIGURE 59. Alert Options Tab
Alert Options. Offers three check boxes for each alert - Dialog, Email, and Sound. This
section displays the following events:
• Locked User - The user is locked out of the login.
• Batch Complete - The batch is finished.
• Warmup Complete - The laser is warmed up.
• Heater In Range - The plate heater is warmed to the designated range.
• Scheduled Maintenance - A scheduled maintenance routine is now due.
• Low Bead Count Detected - A bead count below the accepted range is encountered.
• No Liquid Detected - Readings indicate no liquid.
• Sheath Empty - A problem with the sheath fluid is encountered.
• Routine Complete - The currently running routine is complete.
• Delta Cal Temp Exceeded Tolerance During Batch - The delta cal temperature fell
outside the designated range during the running of the batch.
Select the appropriate check boxes to display a pop-up message, send an email, or play a
sound to alert you when the event occurs. All check boxes are selected by default. Cancel
and Save buttons display if you change a setting.
Speakers Attached/Speakers Not Attached. Enables sounds to be played through
speakers. Click this button if you have speakers attached to your system. The button title
will alternate between attached/not attached status when you click it.
Setup Email. Opens the Setup Email dialog box.