ZOLL AutoPulse 100 - Manual (Page 34)

Page 2-10 P/N 12555-001 Rev 3
User Guide
The AutoPulse Li-Ion Battery is mechanically keyed so that it can only be inserted in one orientation. If
resistance is met, check for appropriate orientation, and check to ensure there are no obstructions to
battery insertion and that the Battery Latch is open.
Ensure that the AutoPulse Li-Ion Battery is securely latched (snaps into place) before moving the
AutoPulse Platform or initiating chest compression. Power on the AutoPulse every time the AutoPulse
Li-Ion Battery is installed to ensure it is properly seated and providing power to the AutoPulse Platform.
To remove the Li-Ion Battery, first rotate the Battery Latch into the open position as shown in Figure 2-
11. Then hold the AutoPulse Platform firmly and pull the Finger Latch away from the AutoPulse
Platform. This will disengage the Locking Bar and allow the AutoPulse Li-Ion Battery to be pulled
straight out until it fully clears the Battery compartment.
Caution: Only use ZOLL Batteries specifically designed for use with the AutoPulse. The use of other
batteries may cause permanent damage to the AutoPulse and will void the warranty.
2.2.2 AutoPulse NiMH Battery Installation and Removal
Figure 2-12 AutoPulse NiMH Battery Installation and Removal
Finger Latch
Battery Latch Opened
Battery Latch Closed
Battery Latch
Locking Bar Battery Front