ZOLL AutoPulse 100 - Manual (Page 63)

P/N 12555-001 Rev 3 Page 3-23
User Guide
6. When a connection is established between the platform and your computer the “Connected” panel
screen will be displayed. If a connection cannot be made within ten minutes the AutoPulse will
automatically power down.
Figure 3-22 Transmitting... Display Panel Screen
7. From your computer send the start transmission of data command. See the Code Review software
User Guide for instructions. The “Transmitting...” panel screen will be displayed while the patient
information is being transferred between the platform and your computer. When the data transfer is
complete the panel screen will return to the Connected display (see Figure 3-21). If while
transmitting data the AutoPulse loses communication with the host computer it will automatically
try to reestablish the connection: repeat procedure starting at step 5 on page 3-22 (see Figure 3-20).
8. To exit from the Communication mode, either power down the platform by pressing the ON/OFF
button or press the “START” (green) button under the word “RESTART.” The AutoPulse will restart
and place you into the idle state, ready for patient alignment.
U p l o a d i n g D a t a . . .